Ultra Stick Hangar 9 Instruction Manual download pdf (Page 53)

Section 19: Programming Guide — JR XP652/642

CONTINUED

MODE

ENTER

A35

CURRENT MIX

CYRRENT MIX

CHANNELS

INCREASE

CLEAR

MIX

+ –

DECREASE

Press the MODE button

until “MIXALL” appears

on the screen.

Step 8. Mixing elevator-to-flaps: Press the Mode key until

the “MIX A11” screen appears. This is programmable MIX A and

it allows you to mix any channel to any other channel or even to

itself. Press the Channel key until the “MIX Ach” appears. This

screen will allow you to select the master (elevator) and slave

(in this case GEAR because GEAR is being used to deploy flaps).

Elevator is channel 3, so press the Increase key until the screen

reads “31.” The first digit (3) is now the master channel

(elevator). Now press the Decrease key until “35” appears in the

screen. The second digit (5) is now the slave channel (gear,

which we have Y-harnessed to flaps). This gives us an elevator-

to-flap mix. Press the Channel key twice until “0%” appears on

the screen. Now hold up elevator and press the Increase key

until 35% is achieved. An up elevator command should result in

the flap going down. If the flaps go up instead, this 35% value

needs to be -35%. Press the Decrease key until -35% is

achieved. Now holding down elevator, press the Increase or

Decrease key so that the flap goes up 35%.

Note: It’s possible to assign this mix to be turned off/on

using a selected switch. Press the Channel key until

“MIX-ASW” appears. Pressing the Increase key will

allow you to assign this mix: F1 = flap switch,

A = aileron dual rate switch, E = elevator dual rate

switch, or ON = always on.

ENTER

B65

CURRENT MIX

CHANNELS

INCREASE

CLEAR

MIX

+ –

DECREASE

Step 9. Crow mixing: We’ve already done

3 of the work in

crow mixing above when we activated the flaperons and adjusted

the ailerons to go up when the flap switch is pulled in Steps 2

and 5. Now we need to add down flaps and some down elevator.

To get down flap when the flap switch is pulled, we’re going to

mix flap as master to gear as slave. Press the Mode key until

“MIXB11” appears on the screen. Now press the Channel key to

access the “MIXBch” screen. Press the Increase key until “61”

appears, then press the Decrease key until “65” appears in the

screen. This programs channel 6 (flaps) as master and channel

5 (gear) as slave. Now press the Channel key until “MIX65 0%”

appears on the screen. With the flap switch pulled forward, press

the Increase key or Decrease key until the flaps go down 1

OFFSET

F-E

ELEVATOR OFFSET VALUE (±125)

INDICATES FLAP TO ELEVATOR

OFFSET TRIM FUNCTION

–

MODE

ENTER

CHANNEL INCREASE

CLEAR

DECREASE

Press the INCREASE or DECREASE

button to adjust the flap elevator

offset value.

Press the MODE button

until “OFFSET F-E” appears

on the screen.

Step 10. Elevator Offset: To set the necessary down elevator

with crow, press the Mode key until “OFFSET F-E” appears on

the screen. With the flap switch in the forward position, press

the Increase or Decrease key until the elevator goes down

/8."

CHANNEL

CHANNELMODE

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Comments to this Manuals

No comments

Ultra Stick Hangar 9 Instruction Manual Page 53

Comments to this Manuals

Related products and manuals for Toys & accessories Ultra Stick Hangar 9