Ultra Stick Hangar 9 Instruction Manual download pdf (Page 67)

Section 19: Programming Guide — JJR XP8103

CONTINUED

Press to increase or

decrease travel value;

move stick or switch to

manipulate arrow to the

position to be adjusted

(high/low, left/right).

Channel

Selection

Reset travel value to

factory preset

(100%).

SELECT

CH CH CLEARUP

Press to display

channels 1-4 and 5-8

(2 screens).

Channel Being Programmed

SPOI Throttle

AIL1 Aileron Right

ELEV Elevator

RUDD Rudder

AIL2 Left Aileron

FLAP Flap (Right)

AUX2 Flap (Left)

Step 8. Setting travel adjust: Press the Up key until the

“TRVL ADJ.” screen appears. Pressing the CH key will allow

access to each channel. Adjust the travel of each channel to the

following throws using the (+) or (-) key. Move the correspond-

ing control stick in the desired direction to adjust the travel

amount in that direction. Press the Select key to access the other

four channels.

Note: To get the most performance out of your Ultra Stick

™

long servo arms (1") are recommended. This provides

for large control throws for more aggressive maneu-

vers. To achieve the control throws listed below, long

servo arms may be necessary.

Throttle — Full open to full closed with trim

(referred to as SPOI in GLID mode)

Aileron — 1

" up, 1

" down

Elevator — 1

/16

" up, 1

/16

" down

Rudder — 3" right, 3" left

Full Flaps — 1

" down

Increase or

Decrease Dual

Rate Value

Channel Selection

(Aile, Elev, Rudd,

Auto Rudd)

Reset Dual Rate Value

to 100%

SELECT

CH CH CLEARUP

Function Select

(Dual Rate or

Exponential)

AILE : Aileron

ELEV : Elevator

RUDD : Rudder

Dual Rate Switch Position

Step 9. Using exponential: Exponential is used to reduce

the sensitivity of control around center while still providing full

control authority when the control stick is fully deflected.

Because the Ultra Stick

™

40 uses large control throws, it’s a good

idea to give expo a try, even if you’ve never used it before, to

help prevent over-controlling. The exponential rate is adjusted in

the same screen as the dual rate from above. In the “D/R & EXP”

screen, press the Select key to move the cursor to the EXP at the

bottom of the screen. Pressing the (+) key will adjust the expo

value. Use the Channel key to select the aileron, elevator or

rudder channel, then use the corresponding dual rate switch to

select position 0 or 1. Separate expo values can be programmed

for position 0 and 1. We recommend an expo value of 30% on

aileron and 25% on elevator and rudder for the first flights then,

on subsequent flights, adjust the value until the desired control

feel is achieved.

Always use A

Expo Value! Using the A

expo value will

actually make control response more sensitive around center

and could cause a crash.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Comments to this Manuals

No comments

Ultra Stick Hangar 9 Instruction Manual Page 67

Comments to this Manuals

Related products and manuals for Toys & accessories Ultra Stick Hangar 9