Ultra Stick Hangar 9 Instruction Manual download pdf (Page 17)

17Hangar 9 Ultra Stick 40 ARF Assembly Manual

 Step 4

Insert the tail gear wire into the rudder. It should fit as shown.

Use 30-minute epoxy to glue only the wire entering the rudder

into the fin.

Rudder Installation

Required Parts

Fuselage assembly Rudder assembly

CA hinge (2)

Tools and Adhesives

Drill bit: 1/16-inch (1.5mm) Pin vise

Hobby knife with #11 blade Thin CA

T-pins

 Step 1

Use a pin vise and 1/16-inch drill bit to drill a hole in the

center of each hinge on both the fin and rudder.

 Step 2

Insert a T-pin in the center of the two CA hinges. Slide the

hinges into the fin.

Note: If you are installing the tail wheel, it will be

necessary to enlarge the slot at the bottom of the fin to

fit the tail gear bushing as shown below.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

No comments

Ultra Stick Hangar 9 Instruction Manual Page 17