Ultra Stick Hangar 9 Instruction Manual download pdf (Page 6)

6 Hangar 9 Ultra Stick 40 ARF Assembly Manual

Aileron Installation (Aileron Only)

Required Parts

Wing panel (right and left)

Aileron, full length (right and left)

CA hinge (8)

Tools and Adhesives

Drill bit: 1/16-inch (1.5mm) Pin vise

Hobby knife with #11 blade Thin CA

Note: There are two wing configurations for your

model, standard two ailerons and quad flaps (ailerons

with flaps). This section covers the installation of the

ailerons for the two aileron versions of your model.

 Step 1

Check to make sure you have the correct aileron. The trim will

match the bottom of the wing.

 Step 2

Use a pin vise and 1/16-inch (1.5mm) drill bit to drill a hole in

the center of each hinge slot. Drill holes for both the aileron

and wing.

 Step 3

Place a T-pin in the center of each hinge. Insert the hinges in

the slots in the trailing edge of the wing. Try to align the slot in

the hinge with the hole drilled in the previous step.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Ultra Stick Hangar 9 Instruction Manual Page 6