Ultra Stick Hangar 9 Instruction Manual download pdf (Page 30)

30 Hangar 9 Ultra Stick 40 ARF Assembly Manual

 Step 4

Measure back 6

-inches (168mm) (tail dragger) or

-inches (317mm) (tricycle gear) and use a hobby knife

to expose the two blind nuts in the fuselage for attaching the

main landing gear.

 Step 5

Apply threadlock to the two 8-32 x 5/8-inch machine screws.

Use the screws and a #2 Phillips screwdriver to attach the

gear. Remember that the angled edge faces to the rear of the

fuselage.Youcanattachthetailwheeltothetailgearatthis

time as well using a 1/16-inch wheel collar and setscrew.

Engine Installation

Required Parts

Fuselage assembly #8 washer (4)

#6 washer (4) 6-32 locknut (4)

Engine Plywood pushrod standoff

Engine mount rail (right and left)

6-32 x 1-inch socket head screw (4)

8-32 x 1-inch socket head screw (4)

Pushrod tube, 13

-inch (350mm) throttle

Pushrod tube, 13

-inch (350mm) nose gear steering

Pushrod, 17

-inch (445mm)

Tools and Adhesives

Drill bit: 9/64-inch (3.5mm), 5/32-inch (4mm)

Drill Nut driver: 5/16-inch

Felt-tipped pen Ruler

Sandpaper Diagonal cutters

Hobby knife with #11 blade Medium CA

Hex wrench: 1/8-inch, 7/64-inch

 Step 1

Use a hobby knife with a #11 blade to remove the covering to

expose the blind nuts and opening for the fuel tank at the front

of the fuselage.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

No comments

Ultra Stick Hangar 9 Instruction Manual Page 30