Ultra Stick Hangar 9 Instruction Manual download pdf (Page 23)

23Hangar 9 Ultra Stick 40 ARF Assembly Manual

Aileron Servo Installation

(Aileron only) or

Flap Servo Installation

(Quad Flap Version)

Required Parts

Wing assembly Control horn (2)

Servo with hardware (2) Pushrod keeper (2)

Control horn backplate (2) Clevis (2)

2-56 x 3/8 machine screw (4) Clevis retainer (2)

Pushrod wire, 6-inch (152mm) (2)

Tools and Adhesives

Pin vise Pliers

Diagonal cutters Felt-tipped pen

Hobby knife with #11 blade Thin CA

String Weight

Phillips screwdriver: #1

Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)

Note: This section is for both the installation of the

aileron servo (aileron only) and for the flap servo (quad

flap) version of your model. The aileron servo for the

quad flap version will be installed in the next section of

the manual.

 Step 1

Use a hobby knife and #11 blade to remove the covering for

the inboard servo in the bottom of the wing.

 Step 2

Tie a weight (wheel collar or nut) to a 12-inch (300mm) piece

of string and lower it into the opening for the servo. Tip the

wing up so the weight can be retrieved at the center of the

wing as shown.

 Step 3

Tie the string around the servo lead. Pull the lead through the

wing and out of the hole at the center.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

No comments

Ultra Stick Hangar 9 Instruction Manual Page 23